Skip to main content
SANtricity 11.6
A newer release of this product is available.

What is redundancy check?

Contributors
PDFs

A redundancy check determines whether the data on a volume in a pool or volume group is consistent. Redundancy data is used to quickly reconstruct information on a replacement drive if one of the drives in the pool or volume group fails.

You can perform this check only on one pool or volume group at a time. A volume redundancy check performs the following actions:

  • Scans the data blocks in a RAID 3 volume, a RAID 5 volume, or a RAID 6 volume, and then checks the redundancy information for each block. (RAID 3 can only be assigned to volume groups using the command line interface.)

  • Compares the data blocks on RAID 1 mirrored drives.

  • Returns redundancy errors if the data is determined to be inconsistent by the controller firmware.

Note

Immediately running a redundancy check on the same pool or volume group might cause an error. To avoid this problem, wait one to two minutes before running another redundancy check on the same pool or volume group.