Provision NAS storage
The requested article is not available. Either it doesn't apply to this version of the product or the relevant information is organized differently in this version of the docs. You can search, browse, or go back to the other version.
Set up NAS path failover (ONTAP 9.7 and earlier)
Contributors
Suggest changes
-
PDF of this doc site
-
Provision NAS storage
-
Provision SAN storage
-
Data protection and disaster recovery
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
This workflow guides you through the networking configuration steps to set up NAS path failover for ONTAP 9.0 - 9.7. This workflow assumes the following:
-
You want to use NAS path failover best practices that simplify network configuration.
-
You want to use the CLI, not System Manager.
-
You are configuring networking on a new system running ONTAP 9.0 to 9.7.
If you are running an ONTAP release later than 9.7, you should use the NAS path failover procedure for ONTAP 9.8 or later:
If you want details about network components and management, you should use the network management reference material:
