Skip to main content
System Manager Classic

Add NFS access to an existing SVM

Contributors netapp-mwallis
PDFs

To add NFS access to an existing SVM, you must first create a data logical interface (LIF). You can then configure NFS access on the ESXi host and verify that NFS is enabled for ESXi using Virtual Storage Console.

Before you begin

  • You must know which of the following networking components the will use:

    • The node and the specific port on that node where the data LIF will be created

    • The subnet from which the data LIF's IP address will be provisioned, or optionally the specific IP address you want to assign to the data LIF

  • Any external firewalls must be appropriately configured to allow access to network services.

  • The NFS protocol must be allowed on the SVM.

    This is the case if you did not follow this procedure to create the SVM while configuring a different protocol.

Steps

  1. Navigate to the Details pane where you can configure the protocols of the SVM:

    1. Select the SVM that you want to configure.

    2. In the Details pane, next to Protocols, click NFS.

      This image is explained by the surrounding text.

  2. In the Configure NFS protocol dialog box, create a data LIF:

    1. Assign an IP address to the LIF automatically from a subnet you specify or manually enter the address.

    2. Click Browse and select a node and port that will be associated with the LIF.

      This graphic is described by the surrounding text.

    Do not enter any information to provision a volume. You can provision datastores later using the Virtual Storage Console.

  3. Click Submit & Close, and then click OK.