Reset the BES-53248 cluster switch to factory defaults
Contributors
Suggest changes
PDFs
To reset the BES-53248 cluster switch to factory defaults, you must erase the BES-53248 switch settings.
About this task
-
You must be connected to the switch using the serial console.
-
This task resets the configuration of the management network.
Steps
-
Change to the elevated command prompt.
(cs2)> enable (cs2)#
-
Erase the startup configuration.
erase startup-config(cs2)# erase startup-config Are you sure you want to clear the configuration? (y/n) y
-
Reboot the switch.
(cs2)# reload Are you sure you would like to reset the system? (y/n) y
|
If the system asks whether to save the unsaved or changed configuration before reloading the switch, select No. |