Skip to main content
Install and maintain

Restore and verify the system configuration - AFX 1K

Contributors netapp-driley netapp-jsnyder
PDFs

Verify that the controller's HA configuration is active and functioning correctly in your AFX 1K storage system, and confirm that the system's adapters list all the paths to the disks.

Step 1: Verify HA config settings

You must verify the HA state of the controller module and, if necessary, update the state to match your system configuration.

  1. Boot to maintenance mode: boot_ontap maint

    1. Enter y when you see Continue with boot?.

      If you see the System ID mismatch warning message, enter y.

  2. Enter sysconfig -v and capture the display contents.

    Note If you see PERSONALITY MISMATCH contact customer support.

  3. From the sysconfig -v output, compare the adapter card information with the cards and locations in the replacement controller.

Step 2: Verify disk list

  1. Verify that the adapter lists the paths to all disks:

    storage show disk -p

    If you see any issues, check cabling and reseat cables.

  2. Exit Maintenance mode:

    halt

What's next?

After restoring and verifying the AFX 1K storage system configuration, give back the controller.