Release notes
The requested article is not available. Either it doesn't apply to this version of the product or the relevant information is organized differently in this version of the docs. You can search, browse, or go back to the other version.
About NDMP modes of operation
Contributors
Suggest changes
-
PDF of this doc site
-
Cluster administration
-
Volume administration
-
Logical storage management with the CLI
-
-
NAS storage management
-
Configure NFS with the CLI
-
Manage NFS with the CLI
-
Manage SMB with the CLI
-
Manage file access using SMB
-
-
-
Security and data encryption
-
Data protection and disaster recovery
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
You can choose to perform tape backup and restore operations either at the node level or at the storage virtual machine (SVM) level. To perform these operations successfully at the SVM level, NDMP service must be enabled on the SVM.
If you upgrade from Data ONTAP 8.2 to Data ONTAP 8.3, the NDMP mode of operation used in 8.2 will continue to be retained post the upgrade from 8.2 to 8.3.
If you install a new cluster with Data ONTAP 8.2 or later, NDMP is in the SVM-scoped NDMP mode by default. To perform tape backup and restore operations in the node-scoped NDMP mode, you must explicitly enable the node-scoped NDMP mode.
Related information
