Upgrading to the 9.8 ONTAP tools for VMware vSphere

You can perform an in-place upgrade to the 9.8 release of ONTAP tools from your existing 9.7 setup following the instructions provided here.

Before you begin

About this task

The status of VASA Provider from the existing deployment is retained after the upgrade. You should manually enable or disable VASA Provider based on your requirement after you upgrade. However, it is best to enable VASA Provider even if VMware Virtual Volumes (vVols) are not in use, as it enables storage capability profiles for traditional datastore provisioning, and storage alarms.
Note: You can perform an in-place upgrade to the 9.8 release of ONTAP tools only from your existing 9.7 version. When you upgrade to 9.7.1 release of ONTAP tools and you want to use vVols replication, then you will need to setup one more vCenter Server with ONTAP tools with Site Recovery Manager (SRM) installed.

Procedure

  1. Mount the downloaded .iso file to the ONTAP tools:
    1. Click Edit Settings > DVD/CD-ROM Drive .
    2. Select Datastore ISO file from the drop-down list.
    3. Browse to and select the downloaded .iso file, and then select the Connect at power on checkbox.
  2. Access the Summary tab of your deployed ONTAP tools.
  3. Click to start the maintenance console.
  4. At the Main Menu prompt, enter option 2 for System Configuration, and then enter option 8 for Upgrade.
    After the upgrade finishes, the ONTAP tools restarts. ONTAP tools is registered to the vCenter Server with the same IP address as before the upgrade.
  5. If you want ONTAP tools to be registered with the vCenter Server with the IPv6 address, then you must perform the following:
    1. Unregister ONTAP tools.
    2. Register the IPv6 address of ONTAP tools to vCenter Server using the Register page.
    3. Regenerate VSC and VASA Provider certificates after the registration.
    Important: IPv6 is supported only with vCenter Server 6.7 and later.
  6. Log out and re-login to the vSphere Client to view the deployed ONTAP tools.
    1. Log out from your existing vSphere web client or vSphere Client and close the window.
    2. Log in to the vSphere Client.
      It might take a few minutes for the plug-in to be updated in the vSphere Client.
      Note:
      • After upgrading from the 7.0 version of ONTAP tools to the latest version of ONTAP tools, you must first create storage capability profiles before attempting to edit an existing VM Storage Policy or you might get an error that there are incorrect or missing values.
      • After upgrading from an earlier version to the 9.8 version of ONTAP tools, it is found that the vvol.rebalance.threshold property is missing in the vvol. properties file.

        The default value of the property is set to 85%.