Skip to main content
ONTAP MetroCluster
简体中文版经机器翻译而成，仅供参考。如与英语版出现任何冲突，应以英语版为准。

还原控制器模块上的系统默认值

贡献者
PDF

重置和还原控制器模块上的默认值。

  1. 在 LOADER 提示符处，将环境变量返回到其默认设置： set-defaults

  2. 将节点启动至启动菜单： boot_ontap menu

    运行此命令后，请等待，直到显示启动菜单为止。

  3. 清除节点配置：

    • 如果您使用的系统配置了ADP、请选择选项 9a 从启动菜单中选择并响应 no 出现提示时。

      备注 此过程会造成中断。

      以下屏幕将显示启动菜单提示符：

      Please choose one of the following:

(1) Normal Boot.
(2) Boot without /etc/rc.
(3) Change password.
(4) Clean configuration and initialize all disks.
(5) Maintenance mode boot.
(6) Update flash from backup config.
(7) Install new software first.
(8) Reboot node.
(9) Configure Advanced Drive Partitioning.
(10) Set Onboard Key Manager recovery secrets.
(11) Configure node for external key management.
Selection (1-11)? 9a
...

########## WARNING: AGGREGATES WILL BE DESTROYED ##########
This is a disruptive operation that applies to all the disks
that are attached and visible to this node.

Before proceeding further, make sure that:

The aggregates visible from this node do not contain
data that needs to be preserved.
This option (9a) has been executed or will be executed
on the HA partner node (and DR/DR-AUX partner nodes if
applicable), prior to reinitializing any system in the
HA-pair or MetroCluster configuration.
The HA partner node (and DR/DR-AUX partner nodes if
applicable) is currently waiting at the boot menu.
Do you want to abort this operation (yes/no)? no

    • 如果您的系统未配置 ADP ，请在启动菜单提示符处键入 wipeconfig ，然后按 Enter 键。

      以下屏幕将显示启动菜单提示符：

    Please choose one of the following:

    (1) Normal Boot.
    (2) Boot without /etc/rc.
    (3) Change password.
    (4) Clean configuration and initialize all disks.
    (5) Maintenance mode boot.
    (6) Update flash from backup config.
    (7) Install new software first.
    (8) Reboot node.
    (9) Configure Advanced Drive Partitioning.
    Selection (1-9)?  wipeconfig
This option deletes critical system configuration, including cluster membership.
Warning: do not run this option on a HA node that has been taken over.
Are you sure you want to continue?: yes
Rebooting to finish wipeconfig request.