La versione in lingua italiana fornita proviene da una traduzione automatica. Per eventuali incoerenze, fare riferimento alla versione in lingua inglese.
Verificare lo stato della configurazione MetroCluster
Collaboratori
Suggerisci modifiche
-
PDF del sito di questa documentazione
-
Aggiornare utilizzando ARL
- Utilizzare i comandi "System controller replace" per aggiornare i modelli di controller nello stesso chassis
-
Aggiornare utilizzando ARL
Raccolta di documenti PDF separati
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
Verificare lo stato della configurazione MetroCluster per verificarne il corretto funzionamento.
Fasi
-
Verificare che i componenti di MetroCluster siano integri:
metrocluster check run
cluster_A::> metrocluster check run Last Checked On: 10/1/2017 16:03:37 Component Result ------------------- --------- nodes ok lifs ok config-replication ok aggregates ok 4 entries were displayed. Command completed. Use the "metrocluster check show -instance" command or sub-commands in "metrocluster check" directory for detailed results. To check if the nodes are ready to do a switchover or switchback operation, run "metrocluster switchover -simulate" or "metrocluster switchback -simulate", respectively.
-
Verificare che non siano presenti avvisi sullo stato di salute:
system health alert show