Install a fabric-attached MetroCluster
Installing FC-to-SAS bridges and SAS disk shelves
Suggest changes
-
PDF of this doc site
-
Install a fabric-attached MetroCluster
-
Install a MetroCluster IP configuration
-
Install a stretch MetroCluster configuration
-
Transition from MetroCluster FC to MetroCluster IP
-
Collection of separate PDF docs
Creating your file...
You install and cable ATTO FibreBridge bridges and SAS disk shelves when adding new storage to the configuration.
For systems received from the factory, the FC-to-SAS bridges are preconfigured and do not require additional configuration.
This procedure assumes that you are using the recommended bridge management interfaces: the ATTO ExpressNAV GUI and ATTO QuickNAV utility.
Use the ATTO ExpressNAV GUI to configure and manage a bridge, and to update the bridge firmware. You use the ATTO QuickNAV utility to configure the bridge Ethernet management 1 port.
You can use other management interfaces instead, if needed, such as a serial port or Telnet to configure and manage a bridge and to configure the Ethernet management 1 port, and FTP to update the bridge firmware.
This procedure uses the following workflow:
