Stretch MetroCluster installation and configuration
Suggest changes
-
PDF of this doc site
- Install a fabric-attached MetroCluster
- Install a MetroCluster IP configuration
- Install a stretch MetroCluster configuration
- Transition from MetroCluster FC to MetroCluster IP
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
This information describes how to install and configure the MetroCluster hardware and software components in a stretch configuration (sometimes referred to as a SAS optical MetroCluster configuration).
You should use this information for planning, installing, and configuring a stretch MetroCluster configuration under the following circumstances:
-
You want to understand the architecture of a stretch MetroCluster configuration.
-
You want to understand the requirements and best practices for configuring a stretch MetroCluster configuration.
-
You want to use the command-line interface (CLI), not an automated scripting tool.