Installing the controller module

After you have replaced the component in the controller module, you must re-install the controller module into the chassis, and then boot it to Maintenance mode.

About this task

You can use the following animation or the written steps to install the controller module in the chassis.

Steps

  1. If you have not already done so, close the air duct.
  2. Align the end of the controller module with the opening in the chassis, and then gently push the controller module halfway into the system.
    Note: Do not completely insert the controller module in the chassis until instructed to do so.
  3. Cable the management and console ports only, so that you can access the system to perform the tasks in the following sections.
    Note: You will connect the rest of the cables to the controller module later in this procedure.
  4. Complete the installation of the controller module:
    1. Plug the power cord into the power supply, reinstall the power cable locking collar, and then connect the power supply to the power source.
    2. Using the locking latches, firmly push the controller module into the chassis until the locking latches begin to rise.
      Note: Do not use excessive force when sliding the controller module into the chassis to avoid damaging the connectors.
    3. Fully seat the controller module in the chassis by rotating the locking latches upward, tilting them so that they clear the locking pins, gently push the controller all the way in, and then lower the locking latches into the locked position.
      The controller module begins to boot as soon as it is fully seated in the chassis. Be prepared to interrupt the boot process.
    4. If you have not already done so, reinstall the cable management device.
    5. Interrupt the normal boot process and boot to LOADER by pressing Ctrl-C.
      Note: If your system stops at the boot menu, select the option to boot to LOADER.
    6. At the LOADER prompt, enter bye to reinitialize the PCIe cards and other components.
    7. Interrupt the boot process and boot to the LOADER prompt by pressing Ctrl-C.
      If your system stops at the boot menu, select the option to boot to LOADER.