Reinstalling the SG6000-CN controller into a cabinet or rack

Reinstall the controller into a cabinet or rack when hardware maintenance is complete.

Before you begin

You have reinstalled the controller cover.

Reinstalling the SG6000-CN controller cover


  1. Press the blue rail releases both rack rails at the same time and slide the SG6000-CN controller into the rack until it is fully seated.

    When you cannot move the controller any further, pull the blue latches on both sides of the chassis to slide the controller all the way in.

    SG6000 Sliding on Rails
    Note: Do not attach the front bezel until after you power on the controller.
  2. Tighten the captive screws on the controller front panel to secure the controller in the rack.

    SG6060 rack retaining screws
  3. Wrap the strap end of the ESD wristband around your wrist, and secure the clip end to a metal ground to prevent static discharge.
  4. Reconnect the controller data cables and any SFP+ or SFP28 transceivers.
    Attention: To prevent degraded performance, do not twist, fold, pinch, or step on the cables.
    Cabling the appliance
  5. Reconnect the controller power cables.

After you finish

The controller can be restarted.

Powering on the SG6000-CN controller and verifying operation