INFORMATIONAL

This message occurs when an HA connection agent connects on an HA interconnect device.

(None).

HA interconnect: Connection for '%s' succeeded.

rv_name (STRING): Logical name of the successful HA connection.

INFORMATIONAL

This message occurs when HA interconnect exchanges flushing information with the partner.

If the flush handle exchange reports "inactive", the remote controller might be running a version of Data ONTAP® that does not support flushing. Make sure that the controller and its partner are running compatible versions of the software.

HA interconnect: Flushing is %s.

s (STRING): Flushing status.

INFORMATIONAL

This message occurs when the local controller votes not to connect to the HA partner. This can be caused by incompatibility between the software versions running on the two controllers.

Install compatible versions of software on both controllers.

HA interconnect: Local controller voted not to connect.

(None).

ERROR

This message occurs when HA interconnects are reset due to NVRAM log being unsynchronized for longier time than 15seconds.

Contact NetApp technical support if the problem persists.

HA interconnect: Reset due to unsynchronized log.

(None).

ALERT

This message occurs when an HA connection agent fails to connect on an HA interconnect device.

Verify that both controllers in the HA pair are operational. If this message persists, disable and reenable the link by using the (privilege: advanced) "system ha interconnect link off" and "system ha interconnect link on" commands.

HA interconnect: Connection for '%s' failed.

rv_name (STRING): Logical name of the failing HA connection.

ERROR

This message occurs when the HA partner votes not to connect to this controller. This can happen if the HA partner detects an incompatibility between the software versions running on the two controllers.

Install compatible versions of software on both controllers.

HA interconnect: Partner voted not to connect.

(None).