Skip to main content
SANtricity commands

Set storage array redundancy mode

Contributors netapp-driley

The set storageArray redundancyMode command sets the redundancy mode of the storage array to either simplex or duplex.

Supported Arrays

This command applies to any individual storage array, including the E2700, E5600, E2800, E5700, EF600 and EF300 arrays, as long as all SMcli packages are installed.

Roles

To execute this command on an E2800, E5700, EF600, or EF300 storage array, you must have the Storage Admin role.

Syntax

set storageArray redundancyMode=(simplex | duplex)

Parameter

Parameter Description

redundancyMode

Use simplex mode when you have a single controller. Use duplex mode when you have two controllers.

Minimum firmware level

6.10