Show drive download progress
The show allDrives downloadProgress
command returns the status of firmware downloads for the drives that are targeted by the download drive firmware
command or the download storageArray driveFirmware
command.
Supported Arrays
This command applies to any individual storage array, including the E4000, E2700, E5600, E2800, E5700, EF600 and EF300 arrays, as long as all SMcli packages are installed.
Roles
To execute this command on an E4000, E2800, E5700, EF600, or EF300 storage array, you must have the Storage Admin role.
Syntax
show allDrives downloadProgress
Parameters
None.
Notes
When all of the firmware downloads have successfully completed, this command returns good status. If any firmware downloads fail, this command shows the firmware download status of each drive that was targeted. This command returns the statuses shown in this table.
Status | Definition |
---|---|
|
The downloads completed without errors. |
|
The downloads did not start. |
|
The downloads are in progress. |
|
The downloads completed with errors. |
Minimum firmware level
6.10