Skip to main content
SANtricity commands

Display AutoSupport bundle collection settings

Contributors netapp-driley
PDFs

The SMcli -autoSupportConfig show command displays the AutoSupport bundle collection settings for the management domain. These settings apply to all of the storage arrays in your management domain for which you have enabled AutoSupport.

Supported Arrays

This command applies to all E2700 and E5600 storage arrays in the management domain at once. It does not apply to E2800 or E5700 storage arrays.

Context

The command output from this command shows the following configuration information:

  • The activation status for this management domain of the AutoSupport feature, the AutoSupport OnDemand feature, and the AutoSupport Remote Diagnostics feature

  • Delivery parameters that depend on the configured delivery method:

    • Delivery method is SMTP: Destination email address, mail relay server, and sender email address are shown

    • Delivery method is HTTP or HTTPs:

      • Direct connection - destination IP address is shown

      • Proxy server connection - Host address, port number, and authentication details are shown

      • Automatic proxy configuration script (PAC) connection - script location is shown

  • A table that lists, for each storage array, the name of the array, whether or not it is an ASUP-capable array, the chassis serial numbers, and the IP addresses for the controllers in the array

Context

Note

This command is an SMcli command, not a script command. You must run this command from a command line. You cannot run this command from the script editor in the storage management software.
Note

This command applies to all E2700 and E5600 storage arrays in the management domain at once. It does not apply to E4000, E2800, or E5700 storage arrays.

Syntax

SMcli -autoSupportConfig show

Parameters

None.

Minimum Firmware Level

8.25

Example output for the activation statuses

The AutoSupport feature is activated on this storage management station.
The AutoSupport OnDemand feature is de-activated on this storage management station.
The AutoSupport Remote Diagnostics feature is de-activated on this storage management station.

Example output for the SMTP delivery method

Delivery method: SMTP
Destination email address:  http://asupserver.corp.netapp.com/put/AsupPut/
Mail relay server: server.eng.netapp.com
Sender email address:  user@netapp.com

Example output for the HTTP or HTTPS delivery method with a direct connection

Delivery method:  HTTP
Destination IP address:  http://asupserver.corp.netapp.com/put/AsupPut/
Connection:  Direct

Example output for the HTTP delivery method with a proxy connection

Connection:  Proxy server
Host Address:  10.227.76.123
Port number: 8080
Authentication required: Yes
User name: admin
Password: **********

Example output for the HTTP delivery method with an automatic proxy configuration script (PAC)

Connection: Automatic proxy configuration script (PAC)
Script location: http://esgweb.eng.netapp.com/~user/proxy.pac

Example output for array table (all delivery methods)

Name  AutoSupport Capable   Chassis Serial Number   IP Address
SA_1  Yes (enabled)         SX94500434              10.113.173.123, 10.113.173.456
SA_2  Yes (disabled)        SX94607107              10.113.174.789, 10.113.174.345
SA_3  No                    Not available           10.113.59.58, 10.113.59.59