Skip to main content
E-Series storage systems

Rack-mount hardware - E-Series

Contributors netapp-lisa netapp-jolieg netapp-driley netapp-jsnyder NetAppZacharyWambold
PDFs

Rack-mount hardware is used to install your storage system in a rack or cabinet. Installation instructions should be included in the rack-mount hardware box. However, if you need to access installation instructions, use the applicable link below.

For newer storage systems, you can verify the supported rack-mount hardware by seeing the NetApp Hardware Universe at NetApp Hardware Universe.

Adjustable support rails

Access Installing adjustable support rails for installing a controller-drive tray or a drive tray that was shipped separately (not already installed in the cabinet). This procedure is applicable for the following 2U (9 cm or 3.5 inch) trays:

  • DE1600 or DE5600

  • E2612 or E2624

  • E5412, E5424, E5512, or E5524

Two-post rack — 2U

Access Installing 2U equipment into a two-post rack.

Four-post rack or cabinet — 2U

Access Installing a 2U 12-drive enclosure in a four-post rack or cabinet.

Four-post rack — SuperRail

Access Install SuperRail into a four-post rack.