Installing a Remote Acquisition Unit (RAU)
-
PDF of this doc site
- Configuration and administration
- Data Warehouse administration
Collection of separate PDF docs
Creating your file...
Install one or more RAUs in your OnCommand Insight environment.
Before you begin
You must have completed all of the installation prerequisites.
At least one port needs to be open and available between the RAU server and the OnCommand Insight Server in order to forward change information to the server. If you are unsure about this, validate it by opening a Web browser on the RAU computer and directing it to the OnCommand Insight server:
https://< OnCommand Insight Server hostname >:< acquisition_port >
The acquisition port defaults to 443, but it may have been changed during the server installation. If the connection is successful, you see a OnCommand Insight response page indicating an open and available port between the RAU and the OnCommand Insight server.
Steps
-
Log in to the RAU server using an account with administrator privileges.
-
Open Windows Explorer and navigate to the directory where the RAU installation file is located.
-
Double-click
.MSI
file to start the installation. -
Click Next to continue to the window that shows the License Agreement. Read this and accept the terms of the License Agreement and click Next.
-
Select to install the RAU on a local hard drive or the entire feature on a local hard drive. (You can check the Disk Usage link to ensure you have enough space - 116MB is required.) Click Next.
-
In the Configure window, set these parameters that are specific to your site:
-
OnCommand Insight Server Name or Address - hostname or IP address to identify the OnCommand Insight Server. The RAU uses this name/IP to open a communications link with the server. If you specify a hostname, make sure it can be resolved through DNS.
-
Acquisition Unit Name - unique name that identifies the RAU.
-
OnCommand Insight Secured Remote Acquisition Port (HTTPS) - Port used by Remote Acquisition Units to send environment change information to the OnCommand Insight server. This setting should match the value entered when installing the OnCommand Insight server and must be the same on all RAUs.
-
Enter the acquisition user password.
-
-
Review your selections. Click Back to go back and make changes. Click Next.
-
Click Install to start the installation.
Wait for the installation to complete. This should take approximately 5 to 10 minutes.
After you finish
When the installation is complete, a final window appears. Click the Start Remote Acquisition Service box to start the RAU, and click Finish to end this operation.
If your data begins acquiring, you are all set; you do not need to synchronize the Server and RAU as noted below.
Synchronize Server and RAU
If data does not begin acquiring after installing the Remote Acquisition Unit, synchronize the RAU with the OnCommand Insight Server. Follow these steps: |
-
On the OnCommand Insight Server system, start the SecurityAdmin tool in interactive mode
securityadmin -i
-
Change the password for the acquisition user for the Insight Server to a password of your choice. Make note of this password as you will require it below.
-
Restart the server/LAU.
-
On the Remote Acquisition Unit (RAU) system, start the SecurityAdmin tool in interactive mode. You will need the password you noted from step 2 above.
securityadmin -i
-
Change the password for the acquisition user to the password used in step 2.
-
Restart the RAU.