Skip to main content
ONTAP 7-Mode Transition

Recovering from a failed LUN transition

Contributors netapp-ivanad
PDFs

If the transition of volumes with LUNs fails, you can use the lun transition 7-mode show command to check which LUNs were not transitioned to ONTAP, and then determine a corrective action.

Steps

  1. Change to advanced privilege level:

    set -privilege advanced

  2. Check which LUNs failed:

    lun transition 7-mode show

  3. Review the EMS logs and determine the corrective action that you must take.

  4. Perform the required steps shown in the EMS message to correct the failure.

  5. If any supported LUNs failed the transition, then to complete the transition:

    lun transition start

  6. View the transition status of the volumes:

    lun transition show

    The transition status can be one of following values:

    • active: The volume is in an active SnapMirror transition relationship and not yet transitioned.

    • complete: All supported LUNs are transitioned for this volume.

    • failed: LUN transition failed for the volume.

    • none: The volume did not contain LUNs to transition from 7-Mode systems.

    cluster1::*> lun transition show
Vserver              Volume             Transition Status
-------------------- ------------------ -----------------
vs1                  vol0               none
                     vol1               complete
                     vol2               failed
                     vol3               active

Related information

Space considerations when transitioning SAN volumes