Skip to main content
System Manager Classic

Verify that the host can write to and read from a multipath device

Contributors NetAppZacharyWambold

Before using a multipath device, you should verify that the host can write data to the multipath device and read it back.

Before you begin

DM-Multipath must be configured on the Linux host for the storage cluster nodes you are accessing.

About this task

If the storage cluster node that the multipath device corresponds to can be failed over to its partner node, you should verify reading the data while the node is failed over. This verification might not be possible if the storage cluster is in production use.

Steps
  1. Run some I/O on the specified multipath device:

    dd if=/dev/zero of=<multipath_device_name\>

  2. Verify that I/O is running on the multipath device, specifying the number of seconds to refresh statistics (for example, every two seconds, as shown):

    iostat 2

    When I/O is running on the multipath device, you can see the various I/O counters output change dynamically, indicating that I/O is running successfully on the multipath device.

    avg-cpu:  %user   %nice %system %iowait  %steal   %idle
                0.00    0.00    0.01    0.00    0.00   99.98
    
    Device:            tps   Blk_read/s   Blk_wrtn/s   Blk_read   Blk_wrtn
    sda               0.18         1.34         2.29     832606    1428026
    dm-0              0.37         1.29         2.29     801530    1427984
    dm-1              0.00         0.00         0.00       2576          0
    dm-2              0.00         0.00         0.00       1770         24
    sdd               0.17         1.18        17.87     734688   11128584
    sde               0.17         1.18        18.01     734560   11219016
    sdf               0.00         0.00         0.00       1344          0
    sdg               0.00         0.00         0.00       1344          0
    dm-3              0.68         4.71        71.96    2932496   44816008
    sdh               0.17         1.18        18.22     734360   11343920
    sdi               0.17         1.18        17.86     734272   11124488
    sdj               0.00         0.00         0.00       1344          0
    sdk               0.00         0.00         0.00       1344          0
    .............
  3. If possible, run the takeover command on the storage cluster node:

    storage failover takeover -ofnode <node_name\>

  4. Verify that I/O is still running on the multipath device by re-running theiostat command.

  5. Run the giveback command on the storage cluster node:

    storage failover giveback -ofnode <node_name\>

  6. Check iostat output to verify that I/O is still running.

What to do next

If any of the tests fail, verify that the FC service is running and re-check the DM-Multipath configuration and the FC paths to the multipath device.