Persistenly disable the switches
Suggest changes
-
PDF of this doc site
-
Upgrade by using ARL
- Use "system controller replace" commands to upgrade controller models in the same chassis
-
Upgrade by using ARL
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
You must disable the switches in the fabric persistently so that you can modify its configuration.
About this task
You disable the switches by running the commands on the switch command line; the commands used for this are not ONTAP commands.
Step
Persistently disable the switch:
-
For Brocade switches, use the
switchCfgPersistentDisable
command. -
For Cisco switches, use the
suspend
command.
The following command disables a Brocade switch persistently:
FC_switch_A_1:admin> switchCfgPersistentDisable
The following command disables a Cisco switch:
vsan [vsna #] suspend