Skip to main content

Remove ownership of disks attached to the new nodes

Contributors netapp-pcarriga
PDFs

If the new nodes have internal disks or add-on shelves attached to the system, these can interfere with the controller upgrade. Use the following steps to remove ownership of any new disks that came with node3/node4.

About this task

These steps are performed on node3 and node4 one after the other. The node sequence does not matter.

Note

  • The shelves from node1 and node2 are not physically connected to node3 and node4 at this stage.

  • You are only required to remove disk ownership for disks and shelves that have come with new controllers.

  • You are not required to remove ownership of disks if you are upgrading the hardware by swapping an old controller with a new controller on an internal drive platform while retaining the chassis and disks of the old controller.

    For example, if you are upgrading your system from an AFF A200 to an AFF A220 by only swapping the old AFF A200 controller module with the new AFF A220 controller module while keeping the chassis and disks of the old AFF A200 in place, you would not remove ownership of disks for the new AFF A220 controller module as outlined in this section Removing ownership of disks attached to the new nodes.

    Contact NetApp technical support if you have questions on removing disk ownership during a controller upgrade.

    The following is a list of systems that have internal storage: FAS2620, FAS2650, FAS2720, FAS2750, AFF A200, AFF A220, AFF A700s, AFF A800, AFF A250.

    If your system is not listed above, see the NetApp Hardware Universe to check if it has internal drives.
Steps

  1. At the LOADER prompt of the node, enter the command:

    boot_ontap menu

  2. At the boot menu prompt, enter 9a and then press Enter.

    The following screen shows the boot menu prompt.

    Please choose one of the following:

    (1) Normal Boot.
    (2) Boot without /etc/rc.
    (3) Change password.
    (4) Clean configuration and initialize all disks.
    (5) Maintenance mode boot.
    (6) Update flash from backup config.
    (7) Install new software first.
    (8) Reboot node.
    (9) Configure Advanced Drive Partitioning.
    Selection (1-9)?  9a

  3. Remove disk ownership by entering y when you see a prompt similar to the following:

    ########## WARNING ##########

This is a disruptive operation and will result in the
    loss of all filesystem data. Before proceeding further,
    make sure that:
    1) This option (9a) has been executed or will be executed
    on the HA partner node, prior to reinitializing either
    system in the HA-pair.
    2) The HA partner node is currently in a halted state or
    at the LOADER prompt.


    Do you still want to continue (yes/no)? yes

    The system removes disk ownership and returns to the boot menu.

  4. At the boot menu, enter 5 to go to maintenance mode.

  5. In maintenance mode, run the disk show command.

    No disks should be listed.

  6. Run the command: `

    disk show -a

    All listed disks should be unassigned.

  7. Exit maintenance mode:

    halt