Shut down the controllers - FAS2600

Contributors netapp-martyh

You must shut down the controller or controller in the chassis prior to moving them to the new chassis.

About this task
  • If you have a cluster with more than two controllers, it must be in quorum. If the cluster is not in quorum or a healthy controller shows false for eligibility and health, you must correct the issue before shutting down the impaired controller; see the Administration overview with the CLI.

  • If AutoSupport is enabled, suppress automatic case creation by invoking an AutoSupport message: system node autosupport invoke -node * -type all -message MAINT=number_of_hours_downh

    The following AutoSupport message suppresses automatic case creation for two hours: cluster1:*> system node autosupport invoke -node * -type all -message MAINT=2h

Steps
  1. If your system has two controller modules, disable the HA pair.

    If your system is running clustered ONTAP with…​ Then…​

    Two controllers in the cluster

    cluster ha modify -configured false storage failover modify -node node0 -enabled false

    More than two controllers in the cluster

    storage failover modify -node node0 -enabled false

  2. Halt the controller, pressing y when you are prompted to confirm the halt: system node halt -node node_name

    The confirmation message looks like the following:

    Warning: This operation will cause controller "node-name" to be marked as unhealthy. Unhealthy nodes do not participate in quorum voting. If the controller goes out of service and one more controller goes out of service there will be a data serving failure for the entire cluster. This will cause a client disruption. Use "cluster show" to verify cluster state. If possible bring other nodes online to improve the resiliency of this cluster.
    
    Do you want to continue? {y|n}:
    Note You must perform a clean system shutdown before replacing the chassis to avoid losing unwritten data in the nonvolatile memory (NVMEM/NVRAM). Depending on your system, if the NVMEM/NVRAM LED is flashing, there is content in the NVMEM/NVRAM that has not been saved to disk. You need to reboot the controller and start from the beginning of this procedure. If repeated attempts to cleanly shut down the controller fail, be aware that you might lose any data that was not saved to disk.
  3. Where applicable, halt the second controller to avoid a possible quorum error message in an HA pair configuration: system node halt -node second_node_name -ignore-quorum-warnings true -skip-lif-migration-before-shutdown true

    Answer y when prompted.