Replace the boot media - FAS9500
PDF of this doc site
- AFF A-series systems
- AFF C-series systems
- ASA A-series systems
- FAS systems
- End-of-availability systems
- Drive shelves
The boot media stores a primary and secondary set of system (boot image) files that the system uses when it boots. Depending on your network configuration, you can perform either a nondisruptive or disruptive replacement.
You must have a USB flash drive, formatted to FAT32, with the appropriate amount of storage to hold the
You also must copy the
image_xxx.tgz file to the USB flash drive for later use in this procedure.
The nondisruptive and disruptive methods for replacing a boot media both require you to restore the
For nondisruptive replacement, the HA pair does not require connection to a network to restore the
varfile system. The HA pair in a single chassis has an internal e0S connection, which is used to transfer
varconfig between them.
For disruptive replacement, you do not need a network connection to restore the
varfile system, but the process requires two reboots.
You must replace the failed component with a replacement FRU component you received from your provider.
It is important that you apply the commands in these steps on the correct node:
The impaired node is the node on which you are performing maintenance.
The healthy node is the HA partner of the impaired node.