Set up NAS path failover (ONTAP 9.0 - 9.7 CLI)

Contributors netapp-barbe Download PDF of this page

This workflow guides you through the networking configuration steps to set up NAS path failover for ONTAP 9.0 - 9.7. This workflow assumes the following:

  • You want to use NAS path failover best practices that simplify network configuration.

  • You want to use the CLI, not ONTAP System Manager.

  • You are configuring networking on a new system running ONTAP 9.0 to 9.7.

If you are running an ONTAP release later than 9.7, you should use the NAS path failover procedure for ONTAP 9.8 or later:

If you want network management details, you should use the following ONTAP 9 Network Management Reference:

If you want to use ONTAP System Manager to configure the network for ONTAP 9.7 and later, you should choose the following documentation:

If you want to use OnCommand System Manager to configure the network for ONTAP 9.7 and earlier, you should choose the following documentation:

If you require additional configuration or conceptual information, you should choose among the following documentation: