Release notes
The requested article is not available. Either it doesn't apply to this version of the product or the relevant information is organized differently in this version of the docs. You can search, browse, or go back to the other version.
Change the CNA/UTA2 target adapter optical modules
Contributors
Suggest changes
-
PDF of this doc site
-
Cluster administration
-
Volume administration
-
Logical storage management with the CLI
-
-
NAS storage management
-
Configure NFS with the CLI
-
Manage NFS with the CLI
-
Manage SMB with the CLI
-
Manage file access using SMB
-
-
-
Security and data encryption
-
Data protection and disaster recovery
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
You should change the optical modules on the unified target adapter (CNA/UTA2) to support the personality mode you have selected for the adapter.
Steps
-
Verify the current SFP+ used in the card. Then, replace the current SFP+ with the appropriate SFP+ for the preferred personality (FC or CNA).
-
Remove the current optical modules from the X1143A-R6 adapter.
-
Insert the correct modules for your preferred personality mode (FC or CNA) optics.
-
Verify that you have the correct SFP+ installed:
network fcp adapter show -instance -node -adapterSupported SFP+ modules and Cisco-branded Copper (Twinax) cables are listed in the Hardware Universe.
Related information
