Configuration information for Vserver
Contributors
Suggest changes
-
PDF of this doc site
-
Administration for Linux
- Role-based access control in SnapDrive for UNIX
-
Installation and Administration for Solaris
- Role-based access control in SnapDrive for UNIX
- Creating and using Snapshot copies in SnapDrive for UNIX
-
Installation and Administration for IBM AIX
- Role-based access control in SnapDrive for UNIX
-
Administration for Linux
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
You must configure Vserver in SnapDrive for UNIX, to perform SnapDrive operations.
To configure Vserver with SnapDrive for UNIX, in clustered DATA ONTAP, ensure that the IP address of the Vserver's management logical interface (LIF) is mapped with the Vserver name, either in Domain Name Service (DNS) or in the /etc/hosts
file. You must also ensure that the Vserver name is configured in SnapDrive for UNIX by using the following command:
snapdrive config set <vsadmin> <Vserver name>
Related information