Specifying login information for the Vserver
Contributors
Suggest changes
-
PDF of this doc site
-
Administration for Linux
- Role-based access control in SnapDrive for UNIX
-
Installation and Administration for Solaris
- Role-based access control in SnapDrive for UNIX
- Creating and using Snapshot copies in SnapDrive for UNIX
-
Installation and Administration for IBM AIX
- Role-based access control in SnapDrive for UNIX
-
Administration for Linux
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
You must specify the user login information for the Vserver. Depending on what you specified when you set up the Vserver, each Vserver must use the configured Vserver user name. If there is a change in your Vserver name, you must ensure that the new Vserver name is configured in SnapDrive for UNIX.
Steps
-
Enter the following command:
snapdrive config set user_name filername [filername…]
-
user_name
is the user name that was specified for the Vserver when you first set it up. The default user is vsadmin.filername
is the Vserver name. -
filer_name
allows you to enter multiple Vservers on one command line if they all have the same user login or password. You must enter at least one Vserver name.# snapdrive config set vsadmin clstr-vs2 Password for vsadmin: Retype password:
-