Adding a port set in SnapDrive
Contributors
Suggest changes
-
PDF of this doc site
-
Administration for Linux
- Role-based access control in SnapDrive for UNIX
-
Installation and Administration for Solaris
- Role-based access control in SnapDrive for UNIX
- Creating and using Snapshot copies in SnapDrive for UNIX
-
Installation and Administration for IBM AIX
- Role-based access control in SnapDrive for UNIX
-
Administration for Linux
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
You can add a port set in the storage system to communicate with a Vserver. This is a one-time activity and must be done before using the storage system.
If you want to upgrade to SnapDrive 5.2 for UNIX, ensure that the earlier versions of SnapDrive for UNIX igroups are manually associated to the port set by the storage administrator. |
In the following example, the storage administrator uses the Vserver name instead of an IP address, and verifies that the Vserver name is registered on a DNS server.
Steps
-
Enter the following command on the host:
snapdrive portset add portset_name filername [filername…]
portset_name
is the name of the port set.filername
is the name of the Vserver.snapdrive portset add ps2 vs91 Added portset configuration for appliance: vs91
The port set ps2 is added successfully in SnapDrive.