Removing the SG6000-CN controller from a cabinet or rack
Remove the SG6000-CN controller from a cabinet or rack to access the top cover or to move the controller to a different location.
-
You have labels to identify each cable that is connected to the SG6000-CN controller.
-
You have physically located the SG6000-CN controller where you are performing maintenance in the data center.
-
You have shut down the SG6000-CN controller.
Do not shut down the controller using the power switch.
-
Label and then disconnect the controller power cables.
-
Wrap the strap end of the ESD wristband around your wrist, and secure the clip end to a metal ground to prevent static discharge.
-
Label and then disconnect the controller data cables and any SFP+ or SFP28 transceivers.
To prevent degraded performance, do not twist, fold, pinch, or step on the cables. -
Loosen the two captive screws on the controller front panel.
-
Slide the SG6000-CN controller forward out of the rack until the mounting rails are fully extended and you hear the latches on both sides click.
The controller top cover is accessible.
-
Optional: If you are fully removing the controller from the cabinet or rack, follow the instructions for the rail kit to remove the controller from the rails.