简体中文版经机器翻译而成,仅供参考。如与英语版出现任何冲突,应以英语版为准。

验证 MetroCluster 配置的运行状况。

您应检查 MetroCluster 配置的运行状况以验证操作是否正确。

步骤
  1. 验证 MetroCluster 组件是否运行正常:

    MetroCluster check run

    cluster_A::> metrocluster check run
    
    Last Checked On: 10/1/2017 16:03:37
    
    Component           Result
    ------------------- ---------
    nodes               ok
    lifs                ok
    config-replication  ok
    aggregates          ok
    4 entries were displayed.
    
    Command completed. Use the "metrocluster check show -instance" command or sub-commands in "metrocluster check" directory for detailed results.
    To check if the nodes are ready to do a switchover or switchback operation, run "metrocluster switchover -simulate" or "metrocluster switchback -simulate", respectively.
  2. 验证是否没有运行状况警报:

    s系统运行状况警报显示