You can use System Manager to configure the node management LIF and Service Processor settings for the newly added nodes.
Before you begin
- Sufficient number of ports must be present in the default IPspace for LIF creation.
- All the ports must be up and running.
Procedure
- Configure node management:
- Enter the IP address in the IP Address field.
- Select the port for node management in the Port field.
- Enter the netmask and gateway details.
- Configure Service Processor settings:
- Select the Override defaults check box to override the default values.
- Enter the IP address, netmask, and gateway details.
- Click Submit and Proceed to complete the network configuration of the nodes.
- Verify the details of the nodes in the Summary page.
After you finish
- If your cluster is protected, you should create the required number of intercluster LIFs in the newly added nodes to avoid partial peering and unhealthy protection.
- If SAN data protocols are enabled in your cluster, you should create the required number of SAN Data LIFs for serving data.