lun transition start
PDF of this doc site
- application commands
- cluster commands
- event commands
- lun commands
- metrocluster commands
- network commands
- qos commands
- security commands
- snaplock commands
- snapmirror commands
- statistics commands
- storage commands
- system commands
- volume commands
- vserver commands
Start LUN Transition Processing
Availability: This command is available to cluster administrators at the advanced privilege level.
lun transition start command starts LUN transition for the specified volume. Normally, transition is started automatically when snapmirror break is issued for the volume, this command allows restarting in the event automatic transitioning was interrupted or failed.
|This command is not supported for a Vserver with Infinite Volume.|
-vserver <Vserver Name>- Vserver Name
The name of the Vserver containing the volume. If only one data Vserver exists, you do not need to specify this parameter.
-volume <volume name>- Volume Name
The name of the volume to restart LUN transition.
The following example starts LUN transition on a volume named
volume1 in a Vserver named
cluster1::*> lun transition start -vserver vs1 -volume volume1