Skip to main content
A newer release of this product is available.

network bgp config modify

Contributors
Suggest changes

Modify BGP configuration

Availability: This command is available to cluster administrators at the advanced privilege level.

Description

The network bgp config modify command is used to modify a node's border gateway protocol (BGP) configuration.

Parameters

-node {<nodename>|local} - Node

This parameter specifies the node on which BGP configuration will be modified.

[-asn <integer>] - Autonomous System Number

This parameter specifies the autonomous system number (ASN). The ASN attribute is a non-negative 16-bit integer. It should typically be chosen from RFC6996 "Autonomous System (AS) Reservation for Private Use" or the AS number assigned to the operator's organization.

[-hold-time <integer>] - Hold Time

This parameter specifies the hold time in seconds.

[-router-id <IP Address>] - Router ID

This parameter specifies the local router ID. The router-id value takes the form of an IPv4 address.

Examples

cluster1::> network bgp config modify -node node1 -router-id 1.1.1.1 -asn 20