Skip to main content
ONTAP tools for VMware vSphere 9.12
A newer release of this product is available.

ESXi host values set using ONTAP tools

Contributors

You can set timeouts and other values on the ESXi hosts using ONTAP tools for VMware vSphere to ensure best performance and successful failover. The values that ONTAP tools sets are based on internal NetApp testing.

You can set the following values on an ESXi host:

ESXi advanced configuration

  • VMFS3.HardwareAcceleratedLocking

    You should set this value to 1.

  • VMFS3.EnableBlockDelete

    You should set this value to 0.

NFS settings

  • Net.TcpipHeapSize

    Set this value to 32.

  • Net.TcpipHeapMax

    Set this value to 1024MB.

  • NFS.MaxVolumes

    Set this value to 256.

  • NFS41.MaxVolumes

    Set this value to 256.

  • NFS.MaxQueueDepth

    Set this value to 128 or higher to avoid queuing bottlenecks.

  • NFS.HeartbeatMaxFailures

    Set this value to 10 for all NFS configurations.

  • NFS.HeartbeatFrequency

    Set this value to 12 for all NFS configurations.

  • NFS.HeartbeatTimeout

    Set this value to 5 for all NFS configurations.

FC/FCoE settings

  • Path selection policy

    Set this value to “RR” (round robin) when FC paths with ALUA are used.

    Set this value to “FIXED” for all other configurations.

    Setting this value to “RR” helps to provide load balancing across all of the active/optimized paths. The value “FIXED” is used for older, non-ALUA configurations and helps to prevent proxy I/O.

  • Disk.QFullSampleSize

    Set this value to 32 for all configurations. Setting this value helps to prevent I/O errors.

  • Disk.QFullThreshold

    Set this value to 8 for all configurations. Setting this value helps prevent I/O errors.

  • Emulex FC HBA timeouts

    Use the default value.

  • QLogic FC HBA timeouts

    Use the default value.

iSCSI settings

  • Path selection policy

    Set this value to “RR” for all iSCSI paths.

    Setting this value to “RR” helps to provide load balancing across all of the active/optimized paths.

  • Disk.QFullSampleSize

    Set this value to 32 for all configurations. Setting this value helps to prevent I/O errors.

  • Disk.QFullThreshold

    Set this value to 8 for all configurations. Setting this value helps prevent I/O errors.