Connect power cords and apply power (SG6000)
-
PDF of this doc site
- Install and maintain appliance hardware
- Install and upgrade software
- Perform system administration
-
Monitor and maintain StorageGRID
-
Recover and maintain
- Grid node recovery procedures
-
Recover and maintain
Collection of separate PDF docs
Creating your file...
After connecting the network cables, you are ready to apply power to the SG6000-CN controller and to the two storage controllers or optional expansion shelves.
-
Confirm that both controllers in the storage controller shelf are off.
Risk of electrical shock — Before connecting the power cords, make sure that the power switches for each of the two storage controllers are off. -
If you have expansion shelves, confirm that both of the IOM power switches are off.
Risk of electrical shock — Before connecting the power cords, make sure that the two power switches for each of the expansion shelves are off. -
Connect a power cord to each of the two power supply units in the SG6000-CN controller.
-
Connect these two power cords to two different power distribution units (PDUs) in the cabinet or rack.
-
Connect a power cord to each of the two power supply units in the storage controller shelf.
-
If you have expansion shelves, connect a power cord to each of the two power supply units in each expansion shelf.
-
Connect the two power cords in each storage shelf (including the optional expansion shelves) to two different PDUs in the cabinet or rack.
-
If the power button on the front of the SG6000-CN controller is not currently illuminated blue, press the button to turn on power to the controller.
Do not press the power button again during the power-on process.
-
Turn on the two power switches on the back of the storage controller shelf. If you have expansion shelves, turn on the two power switches for each shelf.
-
Do not turn off the power switches during the power-on process.
-
The fans in the storage controller shelf and optional expansion shelves might be very loud when they first start up. The loud noise during start-up is normal.
-
-
After the components have booted up, check their status.
-
Check the seven-segment display on the back of each storage controller. Refer to the article about viewing boot-up status codes for more information.
-
Verify that the power button on the front of the SG6000-CN controller is lit.
-
-
If errors occur, correct any issues.
-
Attach the front bezel to the SG6000-CN controller if removed.