Get started
Hardware setup appears to hang (SG6000)
Contributors
Suggest changes
-
PDF of this doc site
-
Install and maintain appliance hardware
-
Install and upgrade software
-
Perform system administration
-
Monitor and maintain StorageGRID
-
Recover and maintain
-
Grid node recovery procedures
-
-
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
The StorageGRID Appliance Installer might not be available if hardware faults or cabling errors prevent the storage controllers or the SG6000-CN controller from completing their boot-up processing.
Steps
-
For the storage controllers, watch the codes on the seven-segment displays.
While the hardware is initializing during power up, the two seven-segment displays show a sequence of codes. When the hardware boots successfully, both seven-segment displays show
99. -
Review the LEDs on the SG6000-CN controller and the boot-up and error codes displayed in the BMC.
-
If you need help resolving an issue, contact technical support.
Related information