Get started
The requested article is not available. Either it doesn't apply to this version of the product or the relevant information is organized differently in this version of the docs. You can search, browse, or go back to the other version.
A newer release of this product is available.
Replace hardware components in optional 60-drive expansion shelf
Contributors
Suggest changes
-
PDF of this doc site
-
Install and maintain appliance hardware
-
SG100 and SG1000 services appliances
-
-
Install and upgrade software
-
Perform system administration
-
Monitor and maintain StorageGRID
-
Recover and maintain
-
Grid node recovery procedures
-
-
-
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
You might need to replace an input/output module, a power supply, or a fan in the expansion shelf.
What you'll need
-
You have the E-Series hardware replacement procedure.
-
You have physically located the storage appliance where you are replacing expansion shelf hardware components in the data center.
About this task
To replace an input/output module (IOM) in a 60-drive expansion shelf, see the instructions in these instructions for replacing a storage controller.
To replace a power supply or a fan in a 60-drive expansion shelf, access the E-Series procedures for maintaining 60-drive hardware.
| FRU | See E-Series instructions for |
|---|---|
Input/output module (IOM) |
Replacing an IOM |
Power canister |
Replace power canister (60-drive) |
Fan canister |
Replace fan canister (60-drive) |
