本繁體中文版使用機器翻譯,譯文僅供參考,若與英文版本牴觸,應以英文版本為準。
在AutoSupport 新節點上設定功能
貢獻者
個別的 PDF 文件集合
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
將節點新增至叢集後、您必須在AutoSupport 節點上設定功能不均。
開始之前
必須在叢集的現有節點上設定。AutoSupport
關於這項工作
您必須在兩個節點上執行此程序。
步驟
-
使用AutoSupport 「系統節點AutoSupport 的flexshow」命令檢視該組態、並將「節點」參數設為原始叢集中的其中一個節點。
cluster1::> system node autosupport show -node cluster1-1 Node: cluster1-1 State: enable SMTP Mail Hosts: smtp.example.com ...
-
在其中一個新增的節點上、使用AutoSupport 「系統節點AutoSupport 更新」命令、以相同的方式設定現有節點上的功能。
cluster1::> system node autosupport modify -node cluster1-3 -state enable -mail-hosts smtp.example.com -from alerts@node3.example.com -to support@example.com -support enable -transport https -noteto pda@example.com -retry-interval 23m
-
針對其他新增的節點、重複上述步驟。