smtape.rst events

12/07/2023 Contributors

smtape.rst.abort.chksum.err

Severity: ERROR
Description: This message occurs when an SMTape restore operation from tape is aborted due to checksum error.
Corrective Action: Make sure that the correct tape is loaded and the tape is positioned correctly. If the tape is corrupted, contact NetApp technical support for the best effort recovery mechanisms.
Syslog Message: SMTape restore session %d to %s from %s was aborted due to checksum error.
Parameters: sessionid (INT): Session ID of the SMTape operation.
dstvolpath (STRING): SMTape destination volume.
tapepath (STRING): Current source device from which restore was performed.

Severity: ERROR
Description: This messages occurs when an SMTape restore operation is aborted because a read from the tape device fails.
Corrective Action: Make sure that the input tape device and media are readable. Check for error details in the log file at /mroot/etc/log/backup.
Syslog Message: SMTape restore session %d to %s from %s was aborted because read from input failed.
Parameters: sessionid (INT): Session ID of the SMTape operation.
dstvolpath (STRING): SMTape destination volume.
tapepath (STRING): Current source device from which restore was performed.

Severity: ERROR
Description: This message occurs when an SMTape restore operation fails.
Corrective Action: Check for error details in the log file at /mroot/etc/log/backup. Retry the command after resolving the error reported.
Syslog Message: SMTape restore session %d to %s from %s failed with error %s.
Parameters: sessionid (INT): Session ID of the SMTape operation.
dstvolpath (STRING): SMTape destination volume.
tapepath (STRING): Current source device from which restore was performed.
errorstring (STRING): Error string returned by SMTape.

Severity: NOTICE
Description: This message occurs when an SMTape restore operation from tape succeeds.
Corrective Action: (None).
Syslog Message: SMTape restore session %d from tape to %s was successful. %s.
Parameters: sessionid (INT): Session ID of the SMTape operation.
dstvolpath (STRING): SMTape destination volume.
stats (STRING): Statistics for the SMTape restore.

Severity: NOTICE
Description: This message occurs when a CLI-based SMTape restore operation from tape reaches end of tape.
Corrective Action: Load the next tape media onto a drive and position it correctly, and then issue the 'system smtape continue -session-id [session-id] -tape [tapepath]' command with the new tape path.
Syslog Message: SMTape restore session %d from %s to %s is waiting for a tape change.
Parameters: sessionid (INT): Session ID of the SMTape operation.
tapepath (STRING): Current source tape device from which restore was performed.
dstvolpath (STRING): SMTape destination volume.