ERROR

This message occurs when an SMTape restore operation from tape is aborted due to checksum error.

Make sure that the correct tape is loaded and the tape is positioned correctly. If the tape is corrupted, contact NetApp technical support for the best effort recovery mechanisms.

SMTape restore session %d to %s from %s was aborted due to checksum error.

sessionid (INT): Session ID of the SMTape operation.
dstvolpath (STRING): SMTape destination volume.
tapepath (STRING): Current source device from which restore was performed.

ERROR

This messages occurs when an SMTape restore operation is aborted because a read from the tape device fails.

Make sure that the input tape device and media are readable. Check for error details in the log file at /mroot/etc/log/backup.

SMTape restore session %d to %s from %s was aborted because read from input failed.

sessionid (INT): Session ID of the SMTape operation.
dstvolpath (STRING): SMTape destination volume.
tapepath (STRING): Current source device from which restore was performed.

ERROR

This message occurs when an SMTape restore operation fails.

Check for error details in the log file at /mroot/etc/log/backup. Retry the command after resolving the error reported.

SMTape restore session %d to %s from %s failed with error %s.

sessionid (INT): Session ID of the SMTape operation.
dstvolpath (STRING): SMTape destination volume.
tapepath (STRING): Current source device from which restore was performed.
errorstring (STRING): Error string returned by SMTape.

NOTICE

This message occurs when an SMTape restore operation from tape succeeds.

(None).

SMTape restore session %d from tape to %s was successful. %s.

sessionid (INT): Session ID of the SMTape operation.
dstvolpath (STRING): SMTape destination volume.
stats (STRING): Statistics for the SMTape restore.

NOTICE

This message occurs when a CLI-based SMTape restore operation from tape reaches end of tape.

Load the next tape media onto a drive and position it correctly, and then issue the 'system smtape continue -session-id [session-id] -tape [tapepath]' command with the new tape path.

SMTape restore session %d from %s to %s is waiting for a tape change.

sessionid (INT): Session ID of the SMTape operation.
tapepath (STRING): Current source tape device from which restore was performed.
dstvolpath (STRING): SMTape destination volume.