ERROR

This message occurs when an FC-to-SAS bridge is attached to an unsupported FC adapter port. Only QLogic® 4-Gb/s or 8-Gb/s adapters are supported.

Attach the FC-to-SAS bridge to a supported FC adapter port on the controller.

FC-to-SAS bridge %s S/N [%s] is attached to unsupported FC adapter port %s.

bridgeName (STRING): Name of the FC-to-SAS bridge.
bridgeSerialNum (STRING): Serial number of the FC-to-SAS bridge.
adapterName (STRING): Name of the associated FC host bus adapter.

ERROR

This message occurs when both FC ports of an FC-to-SAS bridge are attached to the same controller.

Follow the defined Fabric or Stretch MetroCluster wiring guide.

Both FC ports of FC-to-SAS bridge %s S/N [%s] are attached to this controller.

bridgeName (STRING): Name of the FC-to-SAS bridge.
bridgeSerialNum (STRING): Serial number of the FC-to-SAS bridge.

ERROR

This message occurs when two or more attached FC-to-SAS bridges are running different firmware revisions.

For more information about downloading and installing updated firmware, check your support provider's web site or knowledgebase.

Two or more %s FC-to-SAS bridges are running different firmware revisions.

bridgeModel (STRING): Name of the FC-to-SAS bridge model.

ERROR

This message occurs when the SAS disk shelves behind an FC-to-SAS bridge are not wired in the correct order.

Follow the defined Fabric or Stretch MetroCluster wiring guide.

The SAS disk shelves behind FC-to-SAS bridge %s S/N [%s] are not correctly wired.

bridgeName (STRING): Name of the FC-to-SAS bridge.
bridgeSerialNum (STRING): Serial number of the FC-to-SAS bridge.

ERROR

This message occurs when a disk is multipathed to one SAS domain; that is, both ports of the disk are visible from the same bridge FC port.

Recable the disk shelf containing the specified disk, so that the two disk ports are in different SAS domains.

Disk %s is multipathed to the same SAS domain. The two disk ports must be in different SAS domains.

disk (STRING): Name of the disk.

ALERT

This message occurs when an FC-to-SAS bridge discovers a disk shelf that it does not support.

Verify the bridge firmware is up-to-date with minimum FW rev required for support of this shelf type. If the bridge firmware supports the disk shelf but the error condition persists, remove the disk shelf.

FC-to-SAS %s bridge with S/N: %s WWN: %s has unsupported %s shelf type attached.

bridgeType (STRING): Type of FC-to-SAS bridge.
bridgeSerialNum (STRING): Serial number of the bridge.
bridgeWWN (STRING): World Wide Name of the bridge.
shelfType (STRING): Type of shelf.