Skip to main content

Turning the controller identify LED on and off

Contributors netapp-lhalbert
PDFs

The blue identify LED on the front and back of the controller can be turned on to help locate the appliance in a data center.

What you'll need

You must have the BMC IP address of the controller you want to identify.

Steps

  1. Access the controller BMC interface.

  2. Select Server Identify.

  3. Select ON and then select Perform Action.

    Turn on controller identify LED from BMC
Result

The blue identify LEDs light on the front (shown) and rear of the controller.

Front identify LED - on
Note If a bezel is installed on the controller, it might be difficult to see the front identify LED.
After you finish

To turn off the controller identify LED:

  • Press the identify LED switch on the controller front panel.

  • From the controller BMC interface, select Server Identify, select OFF and then select Perform Action.

The blue identify LEDs on the front and rear of the controller go off.

Front identify LED - off
Related information

Verifying the Fibre Channel HBA to replace

Locating the controller in a data center

Accessing the BMC interface