Skip to main content
A newer release of this product is available.

What's next: Perform additional recovery steps, if required

Contributors
PDFs

Depending on the specific actions you took to get the StorageGRID nodes running on the replacement host, you might need to perform additional recovery steps for each node.

Node recovery is complete if you did not need to take any corrective actions while you replaced the Linux host or restored the failed grid node to the new host.

Corrective actions and next steps

During node replacement, you might have needed to take one of these corrective actions:

  • You had to use the --force flag to import the node.

  • For any <PURPOSE>, the value of the BLOCK_DEVICE_<PURPOSE> configuration file variable refers to a block device that does not contain the same data it did before the host failure.

  • You issued storagegrid node force-recovery node-name for the node.

  • You added a new block device.

If you took any of these corrective actions, you must perform additional recovery steps.

Type of recovery Next step

Primary Admin Node

Configure replacement primary Admin Node

Non-primary Admin Node

Select Start Recovery to configure non-primary Admin Node

Gateway Node

Select Start Recovery to configure Gateway Node

Archive Node

Select Start Recovery to configure Archive Node

Storage Node (software-based):

  • If you had to use the --force flag to import the node, or you issued storagegrid node force-recovery node-name

  • If you had to do a full node reinstall, or you needed to restore /var/local

Select Start Recovery to configure Storage Node

Storage Node (software-based):

  • If you added a new block device.

  • If, for any <PURPOSE>, the value of the BLOCK_DEVICE_<PURPOSE> configuration file variable refers to a block device that does not contain the same data it did before the host failure.

Recover from storage volume failure where system drive is intact