Skip to main content
Cluster and storage switches

Overview of installation and configuration for Cisco Nexus 3132Q-V switches

Contributors netapp-jolieg netapp-yvonneo
PDFs

Cisco Nexus 3132Q-V switches can be used as cluster switches in your AFF or FAS cluster. Cluster switches allow you to build ONTAP clusters with more than two nodes.

Initial configuration overview

To initially configure a Cisco Nexus 3132Q-V switch on systems running ONTAP, follow these steps:

  1. Complete Cisco Nexus 3132Q-V cabling worksheet. The sample cabling worksheet provides examples of recommended port assignments from the switches to the controllers. The blank worksheet provides a template that you can use in setting up your cluster.

  2. Install a Cisco Nexus 3132Q-V cluster switch in a NetApp cabinet. install the Cisco Nexus 3132Q-V switch and pass-through panel in a NetApp cabinet with the standard brackets that are included with the switch.

  3. Configure the Cisco Nexus 3132Q-V switch. Set up and configure the Cisco Nexus 3132Q-V switch.

  4. Prepare to install NX-OS software and Reference Configuration File. Prepare to install the NX-OS software and the Reference Configuration File (RCF).

  5. Install the NX-OS software. Follow this procedure to install the NX-OS software on the Nexus 3132Q-V cluster switch.

  6. Install the Reference Configuration File (RCF). Follow this procedure to install the RCF after setting up the Nexus 3132Q-V switch for the first time. You can also use this procedure to upgrade your RCF version.

Additional information

Before you begin installation or maintenance, be sure to review the following: