Skip to main content
A newer release of this product is available.

Prerequisites for deployment

Contributors netapp-aruldeepa
PDFs

You have to install and configure the necessary protocol prerequisites on your host before you can deploy Astra Trident.

Verify the requirements

  • Verify that your deployment meets all of the requirements.

  • Verify that you have a supported version of Docker installed. If your Docker version is out of date, install or update it.

    docker --version

  • Verify that the protocol prerequisites are installed and configured on your host.

NFS tools

Install the NFS tools using the commands for your operating system.

RHEL 8+
sudo yum install -y nfs-utils
Ubuntu
sudo apt-get install -y nfs-common
Warning Reboot your worker nodes after installing the NFS tools to prevent failure when attaching volumes to containers.

iSCSI tools

Install the iSCSI tools using the commands for your operating system.

RHEL 8+

  1. Install the following system packages:

    sudo yum install -y lsscsi iscsi-initiator-utils sg3_utils device-mapper-multipath

  2. Check that iscsi-initiator-utils version is 6.2.0.874-2.el7 or later:

    rpm -q iscsi-initiator-utils

  3. Set scanning to manual:

    sudo sed -i 's/^\(node.session.scan\).*/\1 = manual/' /etc/iscsi/iscsid.conf

  4. Enable multipathing:

    sudo mpathconf --enable --with_multipathd y --find_multipaths n
    Note Ensure etc/multipath.conf contains find_multipaths no under defaults.

  5. Ensure that iscsid and multipathd are running:

    sudo systemctl enable --now iscsid multipathd

  6. Enable and start iscsi:

    sudo systemctl enable --now iscsi
Ubuntu

  1. Install the following system packages:

    sudo apt-get install -y open-iscsi lsscsi sg3-utils multipath-tools scsitools

  2. Check that open-iscsi version is 2.0.874-5ubuntu2.10 or later (for bionic) or 2.0.874-7.1ubuntu6.1 or later (for focal):

    dpkg -l open-iscsi

  3. Set scanning to manual:

    sudo sed -i 's/^\(node.session.scan\).*/\1 = manual/' /etc/iscsi/iscsid.conf

  4. Enable multipathing:

    sudo tee /etc/multipath.conf <<-'EOF'
defaults {
    user_friendly_names yes
    find_multipaths no
}
EOF
sudo systemctl enable --now multipath-tools.service
sudo service multipath-tools restart
    Note Ensure etc/multipath.conf contains find_multipaths no under defaults.

  5. Ensure that open-iscsi and multipath-tools are enabled and running:

    sudo systemctl status multipath-tools
sudo systemctl enable --now open-iscsi.service
sudo systemctl status open-iscsi

NVMe tools

Install the NVMe tools using the commands for your operating system.

Note

  • NVMe requires RHEL 9 or later.

  • If the kernel version of your Kubernetes node is too old or if the NVMe package is not available for your kernel version, you might have to update the kernel version of your node to one with the NVMe package.
RHEL 9
sudo yum install nvme-cli
sudo yum install linux-modules-extra-$(uname -r)
sudo modprobe nvme-tcp
Ubuntu
sudo apt install nvme-cli
sudo apt -y install linux-modules-extra-$(uname -r)
sudo modprobe nvme-tcp