Configure network connections—iSER over Infiniband

If your configuration uses the iSER over Infiniband protocol, perform the steps in this section.

About this task

When you are using a 56-Gbps HIC with the iSER over Infiniband protocol, additional array configuration is required.

Procedure

  1. From the Setup tab, select Configure iSCSI Host Ports to set the storage array iSCSI addresses.
    Put the array iSCSI addresses on the same subnet as the host port(s) you will use to create iSCSI sessions. For addresses, see iSER worksheet.
  2. From the Devices tab, select the storage array and go to iSER > Manage Settings to find the IQN.
    This information might be necessary when you create iSER sessions from operating systems that do not support send targets discovery. Enter this information in the worksheet, in iSER worksheet.