Release notes
The requested article is not available. Either it doesn't apply to this version of the product or the relevant information is organized differently in this version of the docs. You can search, browse, or go back to the other version.
Configure network connections
Contributors
Suggest changes
-
PDF of this doc site
Collection of separate PDF docs
Creating your file...
This may take a few minutes. Thanks for your patience.
Your file is ready
If your configuration uses the iSER over InfiniBand protocol, perform the steps in this section to configure network connections.
Steps
-
From System Manager, go to Settings › System › Configure iSER over Infiniband Ports. Refer to the System Manager online help for further instructions.
Put the array iSCSI addresses on the same subnet as the host port(s) you will use to create iSCSI sessions. For addresses, see your iSER worksheet.
-
Record the IQN.
This information might be necessary when you create iSER sessions from operating systems that do not support send targets discovery. Enter this information in the iSER worksheet.
