Skip to main content
A newer release of this product is available.

Select inventory

Contributors

On the Inventory page, the NetApp Deployment Engine automatically detects available compute and storage nodes, enabling you to select and add all NetApp HCI resources to the deployment. If a node does not meet the requirements for deployment, it is not selectable and problems are indicated as errors. You can position your cursor over the error in the node's row to see an explanation. When choosing node inventory on the Inventory page, the storage node that is hosting the NetApp Deployment Engine is automatically selected, and you cannot deselect it.

What you'll need

Jumbo frames must be enabled for proper inventory detection. If no nodes or only a subset of nodes appear in the inventory, verify that the switch ports used for NetApp HCI nodes (all SFP+/SFP28 interfaces) are configured with jumbo frames.

Steps
  1. On the Inventory page, view the list of available nodes.

    If the system cannot detect any inventory, it displays an error. Correct the error before continuing.
    If your system uses DHCP for IP address assignment, the storage and compute resources might not appear in the inventory immediately.

  2. Optional: If a resource does not appear in the inventory immediately, or if you address an error and need to refresh the inventory, select Refresh Inventory. You might need to refresh the inventory multiple times.

  3. Optional: To filter the inventory on node attributes, such as node type:

    1. Select Filter in the header of the Compute Nodes or Storage Nodes lists.

    2. Choose criteria from the drop-down lists.

    3. Below the drop-down lists, enter information to satisfy the criteria.

    4. Select Add Filter.

    5. Clear individual filters by selecting X next to an active filter, or clear all filters by selecting X above the list of filters.

  4. Select all compute nodes that shipped with your system from the Compute Nodes list.

    You need to select at least two compute nodes to proceed with deployment.

  5. Select all storage nodes that shipped with your system from the Storage Nodes list.

    You need to select at least two storage nodes to proceed with deployment.

  6. Optional: If a storage node selection box is flagged, that storage node exceeds 33% of the total storage cluster capacity. Do of the following:

    • Clear the selection box for the flagged storage node.

    • Select additional storage nodes to more equally distribute the storage cluster capacity between nodes.

  7. Select Continue.